Pre-separator is intended for removal of mist and vapors of oil and emulsion, used for greasing and cooling in metal processing equipment, from air. Main purpose of the installation – significant decreasing of concentration of oil mists at the entrance to main filtration module.
It is possible to use it in a non-standard way for precipitation of mists of other liquids, including general water.
Polluted air enters inner chamber of pre-separator through the inlet duct and passes through drop catcher, where drops of oil and emulsions are settled, and clean air comes out of the outlet in the pre-separator cover and goes into the ventilation network.
Condensed liquids are collected in the bottom of the casing and drained from the pre-separator via connection pipe.
– Equipped with durable cleaning module made of stainless steel
– Efficiency is proved by years of operation in oil and gas industry in a form of columns for drying of associated gases
– Does not require any spares
Pre-separator is designed for long time operation in closed premises at following climatic conditions:
– ambient temperature from 5 to plus 45 °C
– relative humidity not more than 80% at plus 25 °C
|Name of the parameter of characteristic||Parameter value|
|Diameter of connected ducts, mm|
|Max weight, kg|
|600020||PMT1-160-1000||Oil mist pre-separator|
|600021||PMT1-200-2000||Oil mist pre-separator|
|600022||PMT1-250-3000||Oil mist pre-separator|
|600023||PMT1-315-4000||Oil mist pre-separator|
|600024||PMT1-355-5000||Oil mist pre-separator|
Detailed description can be found in the PMT User Manual (see “Documents” tab)
Floor support for pre-separator PS (with fasteners)
Intended for installation of the pre-separator on the floor. Supplied with connection joint for mounting of pre-separator.
Pre-separator bracket BS (with fasteners)
Intended for installation on the pre-separator on the wall. Supplied with connection joint for mounting of pre-separator.
Mounting column for pre-separator MCP (with fasteners)
Attention! MCP column is ordered as an addition to BS bracket. Used for installation of pre-separator on the floor at significant height. Supplied with connection joint for mounting of pre-separator.
|600027||BS1||Pre-separator’s bracket, pre-assembled|
|600028||BS3||Pre-separator’s bracket, pre-assembled|
|600029||MCP1||Pre-separator’s mounting column|
1. Pre-separator’s body
Picture. Dimensions of PMT
|Article||d, mm||D, mm||D1, mm||D2, mm||l1, mm||l2, mm||l3, mm||L, mm||h, mm||H, mm||M, mm|
MT-31/32 Stationary bag filter for oil mist/smoke. Suitable for high viscosity oil-based coolants that may contain metal dust. For continuous 1-2 shift operation.
MT 41/42 Stationary self-draining filter for oilmist/smoke. Suitable for clean low viscosity oil based coolants. For continuous 2-3 shifts operation.